18 Connectors Bitmain Antminer Apw3++ 1600W 1800W 220V 110V

Getting a power cord for your PSU

Power cord is not included in the package, get one that adheres to your local standards. Our APW series uses the C13 cord (normal desktop power cord).

Get a power cord that is at least 10 A. The length should be 1.5 m or less.

Use multiple or different PSUs on a miner

Use one PSU for one miner. The miner can receive power from different PSUs, but each hash board can only receive from just one PSU.

IMPORTANT: Do not use multiple PSUs to power one hash board.

The 6-pin power connectors are interchangeable so the sequence doesn’t matter when connecting the connectors to the miner.

Starting voltage and rated power

Starting voltage is the required voltage of wall outlet to get your PSU working and deliver power to the miner.The starting voltage of this PSU must be at least 95 V.

This PSU cannot be used in countries with main power voltage lower than 95 V.

The rated power of APW3++ is 1600 W at 220 V and 1200 W at 110 V.

• Know the power required for the miners >

1. The APW3++ with 10 connectors can power either the S9/T9 series miners or the L3+. It is fine for both models. It can only power one miner. For S9 it needs 220 V power source.

2. The APW3++ with 18 connectors can power either the S9/T9 series miners or the L3+, too. It is fine for both models. It can only power one S9 miner with 220 V power source. For the L3+ it needs 220 V power source to power two units, it could only power one L3+ with 110 V power source.